Neighbor Filter-List - Allied Telesis SwitchBlade x908 Series Software Reference Manual

neighbor filter-list

This command creates a BGP filter using an AS (Autonomous System) path list. This command
specifies an AS path list, which it then applies to filter updates to and from a BGP neighbor
The no form of this command removes the previously specified filter using access control lists.
Syntax
neighbor <neighborid> filter-list <listname> {in|out}
no neighbor <neighborid> filter-list <listname> {in|out}
Parameter
<neighborid>
<listname>
in
out
Router mode and Address Family [ipv4 unicast | ipv4 multicast] mode
Mode
This command specifies a filter for updates based on a BGP AS (Autonomous System) path list.
Usage
Example
awplus(config-router)#
C613-50007-01 REV B
Description
Identification method for the BGP peer. Use one of the following
formats:
<ip-address>
<tag>
The name of an AS (Autonomous System) path list.
Indicates that incoming advertised routes will be filtered.
Indicates that outgoing advertised routes will be filtered.
awplus# configure terminal
awplus(config)# router bgp 10
neighbor 10.10.0.34 filter-list list1 out
Software Reference for SwitchBlade® x908, x900 and x600 Series Switches
TM
AlliedWare Plus Operating System - Software Version 5.3.1
The address of an IPv4 BGP neighbor, in dotted
decimal notation A.B.C.D.
Name of an existing peer-group. For information on
how to create peer groups, refer to the
peer-group (adding a neighbor) command on
page 38.75, and neighbor remote-as
command on page 38.79. When this parameter is
used with a command, the command applies on all
peers in the specified group.
BGP Commands
neighbor
38.69