Neighbor Dont-Capability-Negotiate - Allied Telesis SwitchBlade x908 Series Software Reference Manual

BGP Commands

neighbor dont-capability-negotiate

Use this command to disable capability negotiation.
The capability negotiation is performed by default. This command is used to allow compatibility
with older BGP versions that have no capability parameters used in open messages between
peers.
Use the no parameter with this command to enable capability negotiation.
Syntax
neighbor <neighborid> dont-capability-negotiate
no neighbor <neighborid> dont-capability-negotiate
Parameter
<neighborid>
Router mode
Mode
Example
awplus(config-router)#
38.66
Description
{<ip-address>|<tag>}
<ip-
address>
<tag>
awplus# configure terminal
awplus(config)# router bgp 10
neighbor 10.10.0.34 dont-capability-negotiate
Software Reference for SwitchBlade® x908, x900 and x600 Series Switches
TM
AlliedWare Plus Operating System - Software Version 5.3.1
Specifies the address of the BGP neighbor in IPv4
format A.B.C.D
.
Name of an existing peer-group. For information on
how to create peer groups, refer to the
peer-group (adding a neighbor) command on
page 38.75, and neighbor remote-as
command on page 38.79. When this parameter
is used with a command, the command applies on all
peers in the specified group.
neighbor
C613-50007-01 REV B