Chapter 17. Vlan Commands; Introduction; Private-Vlan - Allied Telesis SwitchBlade x908 Series Software Reference Manual

VLAN Commands

Introduction

This chapter provides an alphabetized reference for each of the VLAN Commands.

private-vlan

Use this command to a create a private VLAN. Private VLANs can be either primary or
secondary. Secondary VLANs can be ether community or isolated.
Use the no form of this command to remove the specified private vlan.
For more information, see the section
Syntax
private-vlan <vlan-id> {community|isolated|primary}
no private-vlan <vlan-id> {community|isolated|primary}
Parameter
<vlan-id>
community
isolated
primary
VLAN Configuration mode
Mode
Example
17.2
Description
VLAN ID of the vlan which is to be made a private vlan.
Community vlan
Isolated vlan
Primary vlan
awplus#
awplus(config)#
awplus(config-vlan)#
awplus(config-vlan)#
awplus(config-vlan)#
awplus(config-vlan)#
awplus(config-vlan)#
awplus(config-vlan)#
Software Reference for SwitchBlade® x908, x900 and x600 Series Switches
TM
AlliedWare Plus Operating System - Software Version 5.3.1
"Private VLANs" on page
configure terminal
vlan database
vlan 2 name vlan2 state enable
vlan 3 name vlan3 state enable
vlan 4 name vlan3 state enable
private-vlan 2 primary
private-vlan 3 isolated
private-vlan 4 community
16.8.
C613-50007-01 REV B