Neighbor Route-Server-Client - Allied Telesis SwitchBlade x908 Series Software Reference Manual

BGP Commands

neighbor route-server-client

Use this command to specify the peer as route server client.
Use the no parameter with this command to disable this function
Syntax
neighbor <neighborid> route-server-client
no neighbor <neighborid> route-server-client
Parameter
<neighborid>
Router mode and Address Family [ipv4 unicast | ipv4 multicast] mode
Mode
Example
awplus(config-router)#
awplus(config-router)#
38.84
Description
{<ip-address>|<tag>}
<ip-
address>
<tag>
awplus# configure terminal
awplus(config)# router bgp 10
neighbor 10.10.0.72 route-server-client
awplus# configure terminal
awplus(config)# router bgp 10
no neighbor 10.10.0.72 route-server-client
Software Reference for SwitchBlade® x908, x900 and x600 Series Switches
TM
AlliedWare Plus Operating System - Software Version 5.3.1
The address of an IPv4 BGP neighbor, in dotted decimal
notation A.B.C.D.
Name of an existing peer-group. For information on how
to create peer groups, refer to the
group (adding a neighbor) command on page
38.75, and neighbor remote-as command on
page 38.79. When this parameter is used with a
command, the command applies on all peers in the
specified group.
neighbor peer-
C613-50007-01 REV B