Redistributing Routes Into Ospf - Allied Telesis SwitchBlade x908 Series Software Reference Manual

Redistributing routes into OSPF

In this example the configuration causes BGP routes to be imported into the OSPF routing
table and advertised as Type 5 External LSAs into Area 0. In this example, the OSPF
routers, labelled "Device 1-5" represent any Allied Telesis managed Layer 3 switches or Allied
Telesis routers.
Device 1
awplus#configure terminal
awplus(config)#router ospf 100
awplus(config-router)#network
10.10.10.0/24 area 0
awplus(config-router)#redistribute bgp
Names of Commands Used
redistribute,
Validation Commands
show ip ospf database external
C613-50007-01 REV B
AS1
Area 0
AS2
Area 2
Enter the Configure mode.
Configure the Routing process and specify the Process ID
(100). The Process ID should be a unique positive integer
identifying the routing process.
Define one interface (10.10.10.0/24) on which OSPF
runs and associate the area ID (0) with the interface (area ID
0 specifies the backbone area).
Specify redistributing routes from other routing protocol
(BGP) into OSPF.
network area
Software Reference for SwitchBlade® x908, x900 and x600 Series Switches
TM
AlliedWare Plus Operating System - Software Version 5.3.1
Device 2
OSPF
10.10.10.11/24
10.10.10.10/24
Device 1
BGP, OSPF
Device 5
BGP
OSPF Configuration
10.10.10.11/24
10.10.10.12/24
Device 3
Designated
Router
OSPF
ospf_4
35.7