Show File Systems - Allied Telesis SwitchBlade x908 Series Software Reference Manual

File Management Commands

show file systems

This command lists the file systems and their utilization information where appropriate.
If this command is entered on the stack master, it will list the file systems for all the stack
members. A stack member heading is displayed to distinguish the different lists shown for each
stack member. If it is entered on a specific stack member, as a host-directed command, it will
list the file systems for only that stack member.
Syntax show file systems
Privileged Exec mode
Mode
Figure 7-2: Example output from the show file systems command
Output
7.22
STACK member 1:
Size(B) Free(B) Type
Avail
----------------------------------------------------------------
30.0M 6.7M flash
- - system
499.0k 0 nvs
- - sdcard
- - tftp
- - scp
- - sftp
- - http
----------------------------------------------------------------
STACK member 2:
Size(B) Free(B) Type
Avail
----------------------------------------------------------------
30.0M 6.7M flash
- - system
499.0k 0 nvs
- - sdcard
- - tftp
- - scp
- - sftp
- - http
.
.
.
Software Reference for SwitchBlade® x908, x900 and x600 Series Switches
TM
AlliedWare Plus Operating System - Software Version 5.3.1
Flags Prefixes S/D/V
rw flash: static
rw system: virtual local
rw nvs: static
rw card: dynamic local
rw tftp: -
rw scp: -
ro sftp: -
ro http: -
Flags Prefixes S/D/V
rw flash: static
rw system: virtual local
rw nvs: static
rw card: dynamic local
rw tftp: -
rw scp: -
ro sftp: -
ro http: -
Lcl/Ntwk
local Y
-
local Y
N
network -
network -
network -
network -
Lcl/Ntwk
local Y
-
local Y
N
network -
network -
network -
network -
C613-50007-01 REV B