Set Aggregator - Allied Telesis SwitchBlade x908 Series Software Reference Manual

set aggregator

Use this command to add an aggregator set clause to a route map entry.
When a BGP update message matches the route map entry, the device sets the update's
aggregator attribute. The aggregator attribute specifies the AS and IP address of the device that
performed the aggregation.
Use the no parameter to remove the set clause.
Syntax
set aggregator as <asnum> <ip-address>
no set aggregator as [<asnum> <ip-address>]
Parameter
<asnum>
<ip-address>
Route-map mode
Mode
An Autonomous System (AS) is a collection of networks under a common administration
Usage
sharing a common routing strategy. It is subdivided by areas, and is assigned a unique 16-bit
number. Use the set aggregator command to assign an AS number for the aggregator.
This command is valid for BGP update messages only.
To use entry 3 of the route map called myroute to set the aggregator attribute to 43
Examples
10.10.0.3 in matching update messages, use the commands:
awplus(config-route-map)#
route-map
Related Commands
show route-map
C613-50007-01 REV B
Description
The AS number of the aggregator.
The IP address of the aggregator.
awplus#
awplus(config)#
Software Reference for SwitchBlade® x908, x900 and x600 Series Switches
TM
AlliedWare Plus Operating System - Software Version 5.3.1
configure terminal
route-map myroute permit 3
set aggregator as 43 10.10.0.3
Route Map Commands
39.19