Compatible Rfc - Allied Telesis SwitchBlade x908 Series Software Reference Manual

compatible rfc1583

This command changes the method used to calculate summary route to the that specified in
RFC 1583. By default, OSPF uses the method specified in RFC 2328.
RFC 1583 specifies a method for calculating the metric for summary routes based on the
minimum metric of the component paths available. RFC 2328 specifies a method for calculating
metrics based on maximum cost.
It is possible that some ABRs in an area might conform to RFC 1583 and others support RFC
2328, which could lead to incompatibility in their interoperation. This command addresses this
issue by allowing you to selectively disable compatibility with RFC 2328.
Use the no form of this command to disable RFC 1583 compatibility.
Syntax
compatible rfc1583
no compatible rfc1583
Router mode
Mode
Examples
awplus(config-router)#
C613-50007-01 REV B
awplus# configure terminal
awplus(config)# router ospf 100
compatible rfc1583
Software Reference for SwitchBlade® x908, x900 and x600 Series Switches
TM
AlliedWare Plus Operating System - Software Version 5.3.1
OSPF Commands
36.15