Bgp Memory Maxallocation - Allied Telesis SwitchBlade x908 Series Software Reference Manual

bgp memory maxallocation

This command allocates a maximum percentage of the RAM (Random Access Memory)
available on the switch for BGP processes.
When this percentage is exceeded, BGP peering terminates and an out of resources
error displays. The default setting for bgp memory maxallocation is 100% memory
allocation.
The no bgp memory maxallocation command resets memory allocation to the default
value.
Syntax
bgp memory maxallocation <1-100>
no bgp memory maxallocation
Parameter
<1-100>
Global Configuration mode
Mode
BGP processes are allocated the maximum percentage of 100% of the switch's available RAM
Default
memory by default. Note only non-default BGP memory allocation values are shown in the
running or startup configuration files:
awplus#show running-config
!
bgp memory maxallocation 50
!
To limit the maximum amount of memory used by BGP processes to 65% of the total RAM
Example
memory available on the switch, use the commands:
awplus(config)#
To return to the default 100% maximum RAM memory allocation available on the switch for
BGP processes, use the commands:
awplus(config)#
C613-50007-01 REV B
Description
Percentage of switch memory allocated to BGP processes. Note
this is RAM (Random Access Memory), not switch flash memory.
awplus# configure terminal
bgp memory maxallocation 65
awplus# configure terminal
no bgp memory maxallocation
Software Reference for SwitchBlade® x908, x900 and x600 Series Switches
TM
AlliedWare Plus Operating System - Software Version 5.3.1
BGP Commands
38.25