Show Boot - Allied Telesis SwitchBlade x908 Series Software Reference Manual

File Management Commands

show boot

This command displays the current boot configuration.
Syntax
show boot
Privileged Exec mode
Mode
Figure 7-1: Example output from the show boot command
Output
Parameters displayed in the output of the show boot command
Output Parameter
Current software
Current boot image
Backup boot image
Default boot config
Current boot config
To show the current boot configuration, use the command:
Example
boot backup
Related Commands
boot config-file
boot system
7.20
Boot configuration
----------------------------------------------------------------
Current software : r1-5.2.2.rel
Current boot image : flash:/r1-5.3.1.rel
Backup boot image : flash:/r1-5.2.2.rel
Default boot config: flash:/default.cfg
Current boot config: flash:/my.cfg (file exists)
awplus# show boot
Software Reference for SwitchBlade® x908, x900 and x600 Series Switches
TM
AlliedWare Plus Operating System - Software Version 5.3.1
Meaning
The current software release that the device is using.
The boot image currently configured for use during the next
boot cycle.
The boot image to use during the next boot cycle if the device
cannot load the main image.
The default startup configuration file. The device loads this
configuration script if no file is set as the startup-config file.
The configuration file currently configured as the startup-config
file. The device loads this during the next boot cycle.
C613-50007-01 REV B