Neighbor Transparent-Nexthop - Allied Telesis SwitchBlade x908 Series Software Reference Manual

neighbor transparent-nexthop

Use this command to keep the nexthop value of the route even if the peer is an eBGP peer.
Syntax
neighbor <neighborid> transparent-nexthop
Parameter
<neighborid>
Router mode
Mode
Example
awplus(config-router)#
C613-50007-01 REV B
Description
{<ip-address>|<tag>}
The address of an IPv4 BGP neighbor, in dotted decimal
<ip-
address>
notation A.B.C.D.
Name of an existing peer-group. For information on how to
<tag>
create peer groups, refer to the
(adding a neighbor) command on page
neighbor remote-as command on page
this parameter is used with a command, the command applies
on all peers in the specified group.
awplus# configure terminal
awplus(config)# router bgp 12
neighbor 10.10.10.10 transparent-nexthop
Software Reference for SwitchBlade® x908, x900 and x600 Series Switches
TM
AlliedWare Plus Operating System - Software Version 5.3.1
BGP Commands
neighbor peer-group
38.75, and
38.79. When
38.91