Switchport Port-Security Maximum - Allied Telesis SwitchBlade x908 Series Software Reference Manual

Switching Commands

switchport port-security maximum

Sets the maximum MAC address that each port can learn.
Use the no switchport port-security maximum command to unset the maximum
number of MAC addresses that each port can learn. This is same as setting the maximum
number to 0. This command also resets the intrusion list table.
Syntax
switchport port-security maximum <0-256>
no switchport port-security maximum
Parameter
no
switchport
port-security
maximum
<0-256>
Interface Mode
Mode
To learn 3 MAC addresses on port1.0.1, use command:
Example
To remove the MAC learning limit, use command:
15.42
Description
Negate a command or set its defaults
Set the switching characteristics of the Layer2 interface
Port-based learning limits
Maximum number of address to learn
Maximum number of address to learn
awplus(config-if)# switchport port-security maximum 3
awplus(config-if)# no switchport port-security maximum
Software Reference for SwitchBlade® x908, x900 and x600 Series Switches
TM
AlliedWare Plus Operating System - Software Version 5.3.1 C613-50007-01 REV B