Show Static-Channel-Group - Allied Telesis SwitchBlade x908 Series Software Reference Manual

Link Aggregation Commands

show static-channel-group

Use this command to display all configured static channel groups and their corresponding
member ports. Note that a static channel group is the same as a static aggregator.
The command output also shows the thrash limiting status. If thrash limiting is detected and the
thrash limiting parameter of the
disable, the output will also show the VLANs on which thrashing is detected.
Syntax show static-channel-group
Exec and Privileged Exec mode
Mode
Examples
Figure 21-8: Example output from the show static-channel-group command
Output
static-channel-group
Related Commands
21.14
awplus#
% Static Aggregator: sa1
Thrash-limiting
Status Vlan Thrashing Detected, Action vlan-disable,
Timeout 60(s)
Thrashing Vlans: 1 2 3 4 5
% Member:
port1.1.2
port1.1.3
% Static Aggregator: sa2
% Member:
port1.1.4
Software Reference for SwitchBlade® x908, x900 and x600 Series Switches
TM
AlliedWare Plus Operating System - Software Version 5.3.1
thrash-limiting command on page 15.44
show static-channel-group
is set to vlan
C613-50007-01 REV B