Ipv6 Nd Ra-Lifetime - Allied Telesis SwitchBlade x908 Series Software Reference Manual

IPv6 Commands

ipv6 nd ra-lifetime

ipv6 nd ra-lifetime Command
Use this command to specify the time period that this router can usefully act as a default
gateway for the network. Each router advertisement resets this time period.
Use no parameter with this command to reset the value to default.
Syntax
ipv6 nd ra-lifetime <seconds>
no ipv6 nd ra-lifetime <seconds>
Parameter
<seconds>
1800 seconds
Default
Interface mode
Mode
This command specifies the lifetime of the current router to be announced in IPv6 Router
Usage
Advertisements.
Advertisement flags will not be transmitted unless you have applied the
command on page
To set the advertisement lifetime of 8000 seconds on vlan4, use the following commands:
Example
awplus(config-if)#
awplus(config-if)#
ipv6 nd suppress-ra
Related Commands
ipv6 nd prefix
25.8
New vs_531 %flag
Description
Time period in seconds. Valid values are from 0 to 9000.
Note that you should set this time period to a value greater than the
value you have set using the
25.7
25.10. This instruction is included in the example shown below.
awplus# configure terminal
awplus(config)# interface vlan4
ipv6 nd ra-lifetime 8000
no ipv6 nd suppress-ra
Software Reference for SwitchBlade® x908, x900 and x600 Series Switches
TM
AlliedWare Plus Operating System - Software Version 5.3.1
IPv6 Commands This new command is used to specify the time period that this router can usefully act as a default gateway for the network.
ipv6 nd ra-interval command on page
no ipv6 nd suppress-ra
C613-50007-01 REV B