Show Arp - Allied Telesis SwitchBlade x908 Series Software Reference Manual

show arp

This command displays the dynamic and static ARP entries in the ARP cache. The ARP cache
contains mappings of IP addresses to physical addresses for hosts. To have a dynamic entry in
the ARP cache, a host must have used the ARP protocol to access another host.
To modify the lines displayed, use the | (output modifier token); to save the output to a file, use
the > (output redirection token).
Syntax show arp
Exec mode and Privileged Exec mode
Mode
To display the ARP entries in the ARP cache, use the command:
Example
Figure 23-1: Example output from the
Output
Parameters in output of the show arp command
Parameter
IP Address
MAC Address
Interface
Port
Type
arp (IP address MAC address)
Related Commands
clear arp-cache
C613-50007-01 REV B
awplus#
IP Address MAC Address
192.168.2.4 0013.4078.3b98 vlan3
192.168.15.20 0030.940e.136b vlan3
192.168.17.1 0017.9ab6.0369 vlan3
192.168.18.10 0003.376b.a6a5 vlan3
192.168.18.12 0000.cd23.55c4 vlan3
192.168.21.1 0003.476b.a8a9 vlan3
192.168.26.1 0030.846e.9bc5 vlan3
192.168.27.10 0000.f742.ad10 vlan3
192.168.27.100 0000.daaf.cd24 vlan3
192.168.1.100 00d0.6b04.2a42 vlan2
Meaning
IP address of the network device this entry maps to.
Hardware address of the network device.
Interface over which the network device is accessed.
Physical port that the network device is attached to.
Whether the entry is a static or dynamic entry. Static entries are
added using the
Dynamic entries are learned from ARP request/reply message
exchanges.
Software Reference for SwitchBlade® x908, x900 and x600 Series Switches
TM
AlliedWare Plus Operating System - Software Version 5.3.1
show arp
show arp command
Interface
arp (IP address MAC address)
IP Addressing and Protocol Commands
Port Type
port1.0.7 dynamic
port1.0.7 dynamic
port1.0.7 dynamic
port1.0.7 dynamic
port1.0.7 dynamic
port1.0.7 dynamic
port1.0.7 dynamic
port1.0.7 dynamic
port1.0.7 dynamic
port1.0.8 static
command.
23.31