Ip Ospf Retransmit-Interval - Allied Telesis SwitchBlade x908 Series Software Reference Manual

OSPF Commands

ip ospf retransmit-interval

Use this command to specify the time between link-state advertisement (LSA) retransmissions
for adjacencies belonging to the interface.
Use the no parameter with this command to return to the default value of 5 seconds.
Syntax
ip ospf [<ip_address>] retransmit-interval <interval>
no ip ospf [<ip_address>] retransmit-interval
Parameter
<ip_address>
<interval>
Interface mode
Mode
After sending an LSA to a neighbor, the router keeps the LSA until it receives an
Usage
acknowledgement. In case the router does not receive an acknowledgement during the set
time (the retransmit interval value) it retransmits the LSA. Set the retransmission interval value
conservatively to avoid needless retransmission. The interval should be greater than the
expected round-trip delay between two routers.
The following example shows setting the ospf retransmit interval to 6 seconds on
Examples
the vlan2 interface.
36.40
Description
The IP address of the interface.
<1-65535> Specifies the interval in seconds. The default interval is 5
seconds.
awplus# configure terminal
awplus(config)# interface vlan2
awplus(config-if)# ip ospf retransmit-interval 6
Software Reference for SwitchBlade® x908, x900 and x600 Series Switches
TM
AlliedWare Plus Operating System - Software Version 5.3.1 C613-50007-01 REV B