Bgp Scan-Time - Allied Telesis SwitchBlade x908 Series Software Reference Manual

BGP Commands
To disable the router ID for a BGP router identifier issue the commands listed below:
awplus(config-router)#

bgp scan-time

Use this command to set the interval for BGP route next-hop scanning.
Use the no parameter with this command to disable this function.
Syntax
bgp scan-time <time>
no bgp scan-time [<time>]
Parameter
<time>
Router mode
Mode
Use this command to configure scanning intervals of BGP routers. This interval is the period
Usage
after which router checks the validity of the routes in its database.
To disable BGP scanning, set the scan time interval to 0 seconds.
Example
awplus(config-router)#
38.28
awplus# configure terminal
awplus(config)# router bgp 100
no bgp router-id
Description
<0-60> Scanning interval in seconds. The default scanning interval is 60
seconds.
awplus# configure terminal
awplus(config)# router bgp 100
bgp scan-time 10
Software Reference for SwitchBlade® x908, x900 and x600 Series Switches
TM
AlliedWare Plus Operating System - Software Version 5.3.1 C613-50007-01 REV B