Loop-Protection Timeout; Mac Address-Table Acquire - Allied Telesis SwitchBlade x908 Series Software Reference Manual

loop-protection timeout

loop-protection timeout Command
Use this command to specify the Loop Protection recovery action duration.
Syntax
loop-protection timeout <duration>
no loop-protection timeout
Parameter
<duration>
no
Mode Port / Aggregator Interface mode
Example To configure a loop protection action timeout of 10 seconds, use the command:

mac address-table acquire

Use this command to enable or disable MAC address learning on the device.
To disable learning, use the no parameter with this command.
Syntax
mac address-table acquire
no mac address-table acquire
Global Configuration mode
Mode
Learning is enabled by default for all instances.
Default
Examples
awplus(config)#
C613-50007-01 REV B
new vs_531 %flag
Description
The time (in seconds) for which the configured action will apply before
being disabled. This duration can be set between 1 and 86400 seconds (24
hours). The default is 7 seconds.
This variation of the command sets the loop protection timeout to the
default value.
awplus(config)# loop-protection timeout 10
awplus# configure terminal
mac address-table acquire
Software Reference for SwitchBlade® x908, x900 and x600 Series Switches
TM
AlliedWare Plus Operating System - Software Version 5.3.1
Switching Commands This command specifies the Loop Protection recovery action duration.
Switching Commands
15.11