Match Ip Address - Allied Telesis SwitchBlade x908 Series Software Reference Manual

Route Map Commands

match ip address

Use this command to add an IP address prefix match clause to a route map entry. You can
specify the prefix or prefixes to match by either:
■
■
A route matches the route map entry if the route's prefix matches the access list or prefix list.
Each entry of a route map can have at most one access list-based IP address match clause and
one prefix list-based IP address match clause. If the route map entry already has one of these
match clauses, entering this command replaces that match clause with the new clause.
Note that access lists, prefix lists and route map entries all specify an action of deny or permit.
The action in the access list or prefix list determines whether the route map checks update
messages and routes for a given prefix. The route map action and its set clauses determine
what the route map does with routes that contain that prefix.
Use the no parameter to remove the IP address match clause from a route map entry. To
remove a prefix list-based match clause you must also specify the prefix-list parameter.
Syntax
match ip address {<accesslistID>|prefix-list <prefix_listname>}
no match ip address [<accesslistID>]
no match ip address prefix-list <prefix_listname>
Parameter
<accesslistID>
<access-list-name>
<1-199>
<1300-2699>
prefix-list
<prefix_listname>
Route-map mode
Mode
The match ip address command specifies the IP address to be matched. If there is a
Usage
match for the specified IP address, and permit is specified, the route is redistributed or
controlled, as specified by the set action. If the match criteria are met, and deny is specified
then the route is not redistributed or controlled. If the match criteria are not met, the route
is neither accepted nor forwarded, irrespective of permit or deny specifications.
This command is valid for routes in BGP update messages, and for OSPF and RIP routes.
39.6
specifying the name of an access list. To create the access list, enter Global Configuration
mode and use the access-list command.
specifying the name of a prefix list. To create the prefix list, enter Global Configuration
mode and use the ip prefix-list command.
Description
{<access-list-name>|<1-199>|<1300-2699>}
The IP access list name or number
The IP access list name
The IP access list number
The IP access list number (expanded range)
Use an IP prefix list to specify which prefixes to match
The prefix list name
Software Reference for SwitchBlade® x908, x900 and x600 Series Switches
TM
AlliedWare Plus Operating System - Software Version 5.3.1 C613-50007-01 REV B