Passive-Interface (Ipv); Recv-Buffer-Size (Ipv) - Allied Telesis SwitchBlade x908 Series Software Reference Manual

passive-interface (IPv6)
passive-interface (IPv6) Command
Use this command to enable suppression of routing updates on an interface.
Use the no parameter with this command to disable this function.
Syntax passive-interface <ifname>
no passive-interface <ifname>
Parameter
<ifname>
Disabled
Default
Router mode
Mode
Example
awplus(config-router)#
awplus(config-router)#
recv-buffer-size (IPv6)
recv-buffer-size (IPv6) Command
Use this command to configure the RIPng UDP (User Datagram Protocol) receive-buffer size.
This should improve UDP reliability by avoiding UDP receive buffer overruns.
Use the no parameter with this command to unset the configured RIPng UDP receive-buffer
size and set it back to the system default value of 196608 bits.
Syntax
recv-buffer-size <8192-2147483647>
no recv-buffer-size
Router mode
Mode
The RIPng UDP receive-buffer-size is 196608 bits by default, and is reset to the default using
Default
the no recv-buffer-size command.
Example
awplus(config-router)#
C613-50007-01 REV B
New vs_531 %flag
Description
Specifies the name of the interface
awplus# configure terminal
awplus(config)# router ipv6 rip
passive-interface vlan2
awplus# configure terminal
awplus(config)# router ipv6 rip
no passive-interface vlan2
New vs_531 %flag
awplus# configure terminal
awplus(config)# router ipv6 rip
recv-buffer-size 23456789
Software Reference for SwitchBlade® x908, x900 and x600 Series Switches
TM
AlliedWare Plus Operating System - Software Version 5.3.1
RIPng Commands Use this command to enable suppression of routing updates on an interface.
RIPng Commands Use this command to configure the RIPng UDP (User Datagram Protocol) receive-buffer size. This should improve UDP reliability by avoiding UDP receive buffer overruns.
RIPng Commands
34.11