Static-Channel-Group - Allied Telesis SwitchBlade x908 Series Software Reference Manual

static-channel-group

Use this command to create a static channel group (also known as a static aggregator), or add
a member port to an already-existing static channel group. Use the no parameter with this
command to remove the switch port from the static channel group.
Syntax
static-channel-group <1-31>
no static-channel-group
Parameter
<1-31>
Interface mode
Mode
This command adds the switch port to the static channel group with the specified channel
Usage
group number. If the channel group does not exist, it is created, and the port is added to it. The
no prefix detaches the port from the static channel group. If the port is the last member to be
removed, the static channel group is deleted.
All the ports in a channel group must have the same VLAN configuration: they must belong to
the same VLANs and have the same tagging status, and can only be operated on as a group.
Once the static channel group has been created, it is treated as a switch port, and can be
referred to in other commands that apply to switch ports.
To refer to a static channel group in other static channel group commands, use the channel
group number. To specify a static channel group in other commands, prefix the channel group
number with sa. For example, 'sa3' refers to the static channel group with channel group
number 3.
For more on static channel groups, see
Chapter 20, Link Aggregation
To define a static channel group on a switch port apply the example commands shown below:
Example
awplus(config-if)#
C613-50007-01 REV B
Description
Channel group number.
Configuration.
awplus# configure terminal
awplus(config)# interface port1.1.6
static-channel-group 3
Software Reference for SwitchBlade® x908, x900 and x600 Series Switches
TM
AlliedWare Plus Operating System - Software Version 5.3.1
"Static Channel Groups" on page 14.11
Link Aggregation Commands
and
21.15