Show Ip Bgp Paths - Allied Telesis SwitchBlade x908 Series Software Reference Manual

BGP Commands
Figure 38-8: Example output from the

show ip bgp paths

Use this command to display BGP path information.
Syntax
show ip bgp paths
show ip bgp <prefix> paths
Parameter
<prefix>
unicast
multicast
Privileged Exec mode and Exec mode
Mode
Example
38.112
awplus#show ip bgp neighbors
BGP neighbor is 192.10.23.67, remote AS 1, local AS 1,
internal link
BGP version 4, remote router ID 172.22.10.10
BGP state = Established, up for 00:00:22
Last read 00:00:22, hold time is 240, keepalive interval is
60 seconds
Neighbor capabilities:
Route refresh: advertised and received (old and new)
Address family IPv4 Unicast: advertised and received
Received 3 messages, 0 notifications, 0 in queue
Sent 3 messages, 0 notifications, 0 in queue
Route refresh request: received 0, sent 0
Minimum time between advertisement runs is 5 seconds
For address family: IPv4 Unicast
BGP table version 1, neighbor version 1
Index 1, Offset 0, Mask 0x2
AF-dependant capabilities:
Graceful restart: advertised, received
Community attribute sent to this neighbor (both)
0 accepted prefixes
0 announced prefixes
Connections established 1; dropped 0
Graceful-restart Status:
Remote restart-time is 120 sec
Local host: 192.10.23.80, Local port: 33837
Foreign host: 192.10.23.67, Foreign port: 179
Nexthop: 192.10.23.80
Nexthop global: 1111::80
Nexthop local: fe80::203:47ff:fe97:bb79
BGP connection: non shared network
Description
{multicast|unicast}
Specifies a IPv4 unicast address family. This is the default option.
Configures parameters relating to the BGP exchange of routes to unicast
destinations.
Specifies a IPv4 multicast address family. Configures parameters relating to
the BGP exchange of routes to source addresses of multicast streams.
awplus# show ip bgp paths
Software Reference for SwitchBlade® x908, x900 and x600 Series Switches
TM
AlliedWare Plus Operating System - Software Version 5.3.1
show ip bgp neighbors command
C613-50007-01 REV B