Configuring Switch 1 - Allied Telesis SwitchBlade x908 Series Software Reference Manual

Configuring Switch 1

In this example, the ports are all part of the same VLAN and IGMP snooping is enabled. The
switch is running RSTP. This is the default behavior of devices running the AlliedWare Plus OS,
so this example does not describe how to configure RSTP or add the switch ports to a VLAN.
Step 1:
Step 2:
Step 3:
Step 4:
awplus(config-if)#
Step 5:
Commands Used
Use the following links to access command descriptions:
■
■
■
■
■
C613-50007-01 REV B
Enter the configure mode.
Use the command:
awplus# configure terminal
Enable IGMP snooping.
IGMP snooping is enabled by default. Use the following command only if you have
previously disabled it:
awplus(config)# ip igmp snooping
Specify the interface you are configuring.
Specify the interface (vlan1) you are configuring, and enter the Interface mode. Use the
command:
awplus(config)# interface vlan1
Configure the multicast router port.
Configure port1.0.12 as a multicast router port. Use the command:
ip igmp snooping mrouter interface port1.0.2
Validate the configuration.
Use the following commands to validate the configuration:
awplus# show ip igmp interface vlan1
awplus# show ip igmp groups
awplus# show ip igmp snooping mrouter vlan1
ip igmp snooping
ip igmp snooping mrouter
show ip igmp groups
show ip igmp interface
show ip igmp snooping mrouter
Software Reference for SwitchBlade® x908, x900 and x600 Series Switches
TM
AlliedWare Plus Operating System - Software Version 5.3.1
IGMP Snooping Configuration
40.3