Switchport Trunk Native Vlan - Allied Telesis SwitchBlade x908 Series Software Reference Manual

The following shows adding a range of VLANs to the port's member set.
awplus(config-if)#
The following shows adding a list of VLANs to the port's member set.
awplus(config-if)#

switchport trunk native vlan

Use this command to configure the native VLAN for this port. The native VLAN is used for
classifying the incoming untagged packets.
Use the no parameter to revert the native VLAN to the default VLAN ID 1. Command
negation removes all tagged VLANs, and sets the native VLAN to the default VLAN.
Syntax
switchport trunk native vlan {<vid>|none}
no switchport trunk native vlan
Parameter
<vid>
none
VLAN 1 (the default VLAN)
Default
Interface mode
Mode
The following commands show configuration of VLAN 2 as the native vlan for interface port:
Examples
awplus(config-if)#
The following commands revert the native VLAN to the default VLAN 1 for interface port
1.0.2:
awplus(config-if)#
C613-50007-01 REV B
awplus# configure terminal
awplus(config)# interface port1.0.2
switchport trunk allowed vlan add 2-4
awplus# configure terminal
awplus(config)# interface port1.0.2
switchport trunk allowed vlan add 2,3,4
Description
<2-4094> The ID of the VLAN that will be used to classify the
incoming untagged packets. The VLAN ID must be a part of the VLAN
member set of the port.
No native VLAN. Use either the parameter none or no to revert to the
default VLAN 1 as the native VLAN for the specified interface switchport.
awplus# configure terminal
awplus(config)# interface port1.0.2
switchport trunk native vlan 2
awplus# configure terminal
awplus(config)# interface port1.0.2
no switchport trunk native vlan
Software Reference for SwitchBlade® x908, x900 and x600 Series Switches
TM
AlliedWare Plus Operating System - Software Version 5.3.1
VLAN Commands
17.15