Ipv6 Nd Managed-Config-Flag - Allied Telesis SwitchBlade x908 Series Software Reference Manual

IPv6 Commands

ipv6 nd managed-config-flag

ipv6 nd managed-config-flag Command
Use this command to set the managed address configuration flag, contained within the router
advertisement field.
Setting this flag indicates the operation of a stateful autoconfiguration protocol such as
DHCPv6 for address autoconfiguration, and that address information (i.e. the network prefix)
and other (non-address) information can be requested from the switch.
An unset flag enables hosts receiving the advertisements to use a sateless autoconfiguration
mechanism to establish their IPv6 addresses. The default is flag unset.
Use the no parameter to reset this command to its default of, flag unset.
Syntax
ipv6 nd managed-config-flag
no ipv6 nd managed-config-flag
Unset
Default
Interface mode
Mode
Advertisement flags will not be transmitted unless you have applied the
Usage
command on page
To set the flag
Example
awplus(config-if)#
awplus(config-if)#
ipv6 nd suppress-ra
Related Commands
ipv6 nd prefix
ipv6 nd other-config-flag
25.4
New vs_531 %flag
25.10. This step is included in the example below.
awplus# configure terminal
awplus(config)# interface VLAN2
ipv6 nd managed-config-flag
no ipv6 nd suppress-ra
Software Reference for SwitchBlade® x908, x900 and x600 Series Switches
TM
AlliedWare Plus Operating System - Software Version 5.3.1
IPv6 Commands This new command is used to set the managed address configuration flag, contained within the router advertisement field.
no ipv6 nd suppress-ra
C613-50007-01 REV B