Show Ip Ospf Interface - Allied Telesis SwitchBlade x908 Series Software Reference Manual

show ip ospf interface

Use this command to display interface information for OSPF.
To modify the lines displayed, use the | (output modifier token) ; to save the output to a file,
use the > output redirection token.
Syntax
show ip ospf interface <interface-name>
Parameter
<interface-name>
Exec mode and Privileged Exec mode
Mode
Figure 36-18: Example output from the
Output
command
Examples
awplus#
C613-50007-01 REV B
Description
An alphanumeric string that is the interface name.
VLAN1 is up, line protocol is up
Internet Address 1.1.1.1/24, Area 0.0.0.0, MTU 1500
Process ID 0, Router ID 33.33.33.33, Network Type BROADCAST,
Cost: 10
Transmit Delay is 1 sec, State Waiting, Priority 1, TE Metric 0
No designated router on this network
No backup designated router on this network
Timer intervals configured, Hello 10, Dead 40, Wait 40,
Retransmit 5
Hello due in 00:00:02
Neighbor Count is 0, Adjacent neighbor count is 0
Crypt Sequence Number is 1106347721
Hello received 0 sent 1, DD received 0 sent 0
LS-Req received 0 sent 0, LS-Upd received 0 sent 0
LS-Ack received 0 sent 0, Discarded 0
show ip ospf interface port1.0.2
Software Reference for SwitchBlade® x908, x900 and x600 Series Switches
TM
AlliedWare Plus Operating System - Software Version 5.3.1
show ip ospf interface <interface-name>
OSPF Commands
36.73