Match Ipv6 Next-Hop - Allied Telesis SwitchBlade x908 Series Software Reference Manual

match ipv6 next-hop

Use this command to specify a next-hop address to be matched by the route-map.
Use the no parameter with this command to disable this function
Syntax
match ipv6 next-hop {<access-list-name>|<ipv6-address>|prefix-list
<prefix-listname>}
no match ipv6 next-hop [<access-list-name>|<ipv6-address>|prefix-list
[<prefix-listname>]]
Parameter
<access-list-name>
<ipv6-address>
<prefix-listname>
Route-map mode
Mode
The match ipv6 next-hop command specifies the next-hop address to be matched. If
Usage
there is a match for the specified next-hop address, and permit is specified, the route is
redistributed or controlled as specified by the set action. If the match criteria are met, and
deny is specified, the route is not redistributed or controlled. If the match criteria are not met,
the route is neither accepted nor forwarded, irrespective of permit or deny specifications.
Note:
Examples
awplus(config-route-map)#
C613-50007-01 REV B
Description
The name of the IPv6 access list that specifies criteria for the
addresses to match.
Specifies the IPv6 address of next hop, entered in the form
X:X::X:X
The name of the IPv6 prefix list that specifies criteria for the
addresses to be matched.
This command is valid only for BGP.
awplus#
awplus(config)#
Software Reference for SwitchBlade® x908, x900 and x600 Series Switches
TM
AlliedWare Plus Operating System - Software Version 5.3.1
configure terminal
route-map rmap1 permit 3
match ipv6 next-hop 3ffe::1
Route Map Commands
39.11