Arp (Ip Address Mac Address) - Allied Telesis SwitchBlade x908 Series Software Reference Manual

arp (IP address MAC address)

This command adds a static ARP entry to the ARP cache. This is typically used to add entries
for hosts that do not support ARP or to speed up the address resolution function for a host.
The ARP entry must not already exist. Use the alias parameter to allow your device to respond
to ARP requests for this IP address.
The no form removes the static ARP entry. Use the
dynamic ARP entries in the ARP cache.
Syntax
arp <ip-address> <mac-address> [<port-number>] [alias]
no arp <ip-address>
Parameter
<ip-address>
<mac-address>
<port-number>
alias
Global Configuration mode
Mode
To add the IP address 10.10.10.9 with the MAC address 0010.2533.4655 into the ARP cache,
Example
and have your device respond to ARP requests for this address, use the command:
clear arp-cache
Related Commands
ip proxy-arp
show arp
C613-50007-01 REV B
Description
IPv4 address of the device you are adding as a static ARP entry, entered
in dotted decimal notation in the A.B.C.D format.
MAC address of the device you are adding as a static ARP entry, in
hexadecimal notation with the format HHHH.HHHH.HHHH.
The port number associated with the IP address. Specify this when the
IP address is part of a VLAN.
Allows your device to respond to ARP requests for the IP address.
Proxy ARP must be enabled on the interface before using this
parameter.
awplus(config)# arp 10.10.10.9 0010.2355.4566 alias
Software Reference for SwitchBlade® x908, x900 and x600 Series Switches
TM
AlliedWare Plus Operating System - Software Version 5.3.1
IP Addressing and Protocol Commands
clear arp-cache command to remove the
23.3