Storm-Control Level - Allied Telesis SwitchBlade x908 Series Software Reference Manual

storm-control level

Use this command to specify the threshold level for broadcasting, multicast, or destination
lookup failure (DLF) traffic for the port. Storm control limits the specified traffic type to the
specified threshold.
Use the no parameter with this command to disable storm control for broadcast, multicast or
DLF traffic.
Syntax storm-control {broadcast|multicast|dlf} level <level>
no storm-control {broadcast|multicast|dlf} level
Parameter
<level>
broadcast
multicast
dlf
By default, storm control is disabled.
Default
Interface mode
Mode
To limit broadcast traffic on port 1.0.2 to 30% of the maximum port speed, use the command:
Example
C613-50007-01 REV B
Description
<0-100> Specifies the threshold as a percentage of the maximum port
speed.
Applies the storm control to broadcast frames.
Applies the storm control to multicast frames.
Applies the storm control to destination lookup failure traffic.
awplus# configure terminal
awplus(config)# interface port1.0.2
awplus(config-if)# storm-control broadcast level 30
Software Reference for SwitchBlade® x908, x900 and x600 Series Switches
TM
AlliedWare Plus Operating System - Software Version 5.3.1
Switching Commands
15.39