Ip Ospf Authentication - Allied Telesis SwitchBlade x908 Series Software Reference Manual

OSPF Commands

ip ospf authentication

This command sets the authentication method used when sending and receiving OSPF packets
on the current interface. The default is to use no authentication.
If no authentication method is specified in this command, then plain text authentication will be
used.
The no form of this command disables the authentication.
Use the ip ospf authentication-key command to specify a Simple Text password. Use the
ip ospf message-digest-key command to specify MD5 password.
Syntax
ip ospf [<ip-address>] authentication [message-digest|null]
no ip ospf [<ip-address>] authentication
Parameter
<ip-address>
message-digest
null
Interface mode
Mode
In this example, interface vlan1 is configured to have no authentication. This will override any
Examples
text or MD5 authentication configured on this interface.
ip ospf authentication-key
Related Commands
area authentication
ip ospf message-digest-key
36.28
Description
The IP address of the interface.
Use the message digest authentication.
Use no authentication. It overrides password or message-digest
authentication of the interface.
awplus# configure terminal
awplus(config)# interface vlan1
awplus(config-if)# ip ospf authentication null
Software Reference for SwitchBlade® x908, x900 and x600 Series Switches
TM
AlliedWare Plus Operating System - Software Version 5.3.1 C613-50007-01 REV B