Neighbor Activate - Allied Telesis SwitchBlade x908 Series Software Reference Manual

neighbor activate

Use this command to enable the exchange of routes with a neighboring router, possibly within
a specific address-family.
Use the no parameter with this command to disable exchange of information with a neighbor.
Syntax
neighbor <neighborid> activate
no neighbor <neighborid> activate
Parameter
<neighborid>
Router mode and Address Family [ipv4 unicast | ipv4 multicast] mode
Mode
This command triggers the switch to start a BGP peering relationship with the specified
Usage
neighbor and start exchanging routes with that neighbor. To enable the exchange of multicast
NLRIs (Network Layer Reachability Information), neighbors are activated using the neighbor
activate command in multicast address family mode.
To enable an exchange of routes with a neighboring router enter the commands shown below:
Example
awplus(config-router)#
To enable an exchange of multicast NLRI (Network Layer Reachability Information) with a
neighboring router enter the commands shown below:
awplus(config-router-af)#
neighbor remote-as
Related Commands
C613-50007-01 REV B
Description
{<ip-address>|<tag>}
<ip-
address>
<tag>
awplus# configure terminal
awplus(config)# router bgp 10
neighbor 1.2.3.4 activate
awplus#
awplus(config)#
awplus(config-router)#
Software Reference for SwitchBlade® x908, x900 and x600 Series Switches
TM
AlliedWare Plus Operating System - Software Version 5.3.1
The address of an IPv4 BGP neighbor, in dotted decimal
notation A.B.C.D.
Name of an existing peer-group. For information on how to
create peer groups, refer to the
(adding a neighbor) command on page
neighbor remote-as command on page
When this parameter is used with a command, the
command applies on all peers in the specified group.
configure terminal
router bgp 100
address-family ipv4 multicast
neighbor 10.10.10.0 activate
BGP Commands
neighbor peer-group
38.75, and
38.79.
38.53