Log Monitor (Filter) - Allied Telesis SwitchBlade x908 Series Software Reference Manual

log monitor (filter)

Creates a filter to select messages to be sent to the terminal when the terminal monitor
command is given. Selection can be based on the priority/severity of the message, the program
that generated the message, the logging facility used, a sub-string within the message or a
combination of some or all of these. By default there is a filter to select all messages. This filter
may be removed and replaced by filters that are more selective.
Syntax
log monitor
no log monitor
Parameter
log
monitor
no
level
<level>
C613-50007-01 REV B
[level <level>]
[program <program-name>]
[facility <facility>]
[msgtext <text-string>]
[level <level>]
[program <program-name>]
[facility <facility>]
[msgtext <text-string>]
Description
Logging control
Set monitor logging parameters
Deletes the specified filter, so that corresponding messages are no longer
sent to the permanent log.
Filter messages to the permanent log by severity level.
The minimum severity of message to send to the log. The level can be
specified as one of the following numbers or level names, where 0 is the
highest severity and 7 is the lowest severity:
0|emergencies:
1|alerts
2|critical
3|errors
4|warnings
5|notices
6|informational
7|debugging
Software Reference for SwitchBlade® x908, x900 and x600 Series Switches
TM
AlliedWare Plus Operating System - Software Version 5.3.1
System is unusable
Action must be taken immediately
Critical conditions
Error conditions
Warning conditions
Normal, but significant, conditions
Informational messages
Debug-level messages
Logging Commands
10.27