ADTRAN AOS Version R10.1.0 Command Reference Manual page 2612

Command Reference Guide
ip access-policy <ipv4 acp name>
Use the ip access-policy command to assign a specified Internet Protocol version 4 (IPv4) access control
policy (ACP) to an interface. IPv4 ACPs are applied to IPv4 traffic entering an interface. Use the no form
of this command to remove an ACP association. For more information on using IPv4 ACPs, refer to
policy-class <ipv4 acp name> on page
Configured IPv4 ACPs will only be active if the ip firewall command has been entered at
the Global Configuration mode prompt to enable the AOS IPv4 security features. All
configuration parameters are valid, but no security data processing will be attempted
unless the security features are enabled.
Syntax Description
<ipv4 acp name>
Default Values
By default, there are no configured IPv4 ACPs associated with an interface.
Command History
Release 2.1
Release 5.1
Release 6.1
Release 15.1
Release 17.9
Release R10.1.0
Functional Notes
To assign an IPv4 ACP to an interface, enter the interface configuration mode for the desired interface and
enter ip access-policy <ipv4 acp name>.
Usage Examples
The following example associates the IPv4 ACP PRIVATE (to allow inbound IPv4 traffic to the Web server)
to the Ethernet interface 0/1:
Enable the AOS security features:
(config)#ip firewall
60000CRG0-35E
1058.
Identifies the configured IPv4 ACP by alphanumeric descriptor (all ACP
descriptors are case sensitive).
Command was introduced.
Command was expanded to include the Ethernet subinterfaces.
Command was expanded to include the virtual local area network (VLAN)
interfaces.
Command was expanded to include the bridged virtual interfaces (BVIs).
Command was changed to require the ip keyword for ADTRAN
internetworking products only.
Command was changed to require the ip keyword for ADTRAN voice
products.
Copyright © 2012 ADTRAN, Inc.
Tunnel Interface Command Set
ip
2612