Ethernet Oam Lfm Remote-Loopback - Juniper JUNOSE SOFTWARE FOR E SERIES 11.3.X - COMMAND REFERENCE A TO M 2010-10-19 Command Reference Manual

ethernet oam lfm remote-loopback

Syntax
Release Information
Description
Options
Mode
Related
Documentation
Copyright © 2010, Juniper Networks, Inc.
ethernet oam lfm remote-loopback { start | stop } interfaceType interfaceSpecifier
Command introduced in JunosE Release 11.1.0.
Enables or disables remote loopback functionality on the remote OAM entity. Also causes
the remote peer to commence or halt sending of all received frames from the local entity
to the specified interface, except OAM PDUs, without any changes made to the frames.
OAM PDUs continue to be processed. By default, the remote peer does not loop back
the non-OAM PDUs that it receives from the local entity. There is no no version.
This configuration setting is not preserved across a reboot.
start—Commences the remote loopback operation on the remote OAM entity
stop—Halts the remote loopback operation on the remote OAM entity; this is the default
behavior
interfaceType—One of the following interface types listed in "Interface Types and
Specifiers" on page 5
fastEthernet
gigabitEthernet
tenGigabitEthernet
interfaceSpecifier—Particular interface; format varies according to interface type; see
Interface Types and Specifiers on page 5
Privileged Exec
OAM Remote and Local Loopback Feature
ethernet oam lfm remote-loopback supported on page 590
Configuring 802.3ah OAM Link-Fault Management
Example: Enabling Remote Loopback Support on the Local Interface
Chapter 6: E Commands
589