Address Receive Version - Juniper JUNOSE 11.1.X - COMMAND REFERENCE A TO M 4-9-2010 Command Reference Manual

address receive version

address { ipAddress | unnumbered interfaceType interfaceSpecifier }
Syntax
receive version { 1 | 2 | 1 2 | 2 1 | off }
no address [ ipAddress | unnumbered interfaceType interfaceSpecifier ] receive version
Command introduced before JUNOSe Release 7.1.0.
Release Information
Restricts the RIP version that the router can receive on an interface. The no version
Description
sets the interface back to the default value, receiving both RIP version 1 and version 2.
Options
Address Family Configuration, Router Configuration
Mode
ipAddress Address of IP interface where RIP will be run
unnumbered Specifies that RIP will be run on an unnumbered interface
interfaceType Interface type; see "Interface Types and Specifiers" on page 5
interfaceSpecifier—Particular interface; format varies according to interface
type; see Interface Types and Specifiers on page 5
1 Specifies RIP version 1 only
2 Specifies RIP version 2 only
1 2 Specifies RIP version 1 and version 2; the default value
2 1 Specifies RIP version 2 and version 1
off Turns reception off
Chapter 2: A Commands
address receive version
103