Description
Related command:
Example
display atm class
Syntax
View
Parameter
Description
Example
Use the
command to specify the clock signal to be adopted by an ATM
clock
interface.
Use the
undo clock
By default, ATM interface uses line clock signal (slave). This clock signal is usually
provided by device which provides ATM interfaces.
When two network devices are connected back-to-back through their ATM
interfaces, you need to configure one interface to adopt the signal of the internal
transmission clock.
n
The effect of this command applies to both ATM main interface and sub-interface.
However, the command is available only in ATM main interface view.
display atm interface.
# Specify ATM 1/0 interface to adopt the signal of the internal transmission clock.
<Sysname> system-view
[Sysname] interface atm 1/0
[Sysname-Atm1/0] clock master
display atm class [ atm-class-name ]
Any view
atm-class-name: ATM class name, a string of 1 to 16 characters.
Use the
display atm class
class.
Note that:
If you provide the atm-class-name argument, this command displays the
■
information about the ATM class identified by the argument.
If you do not specify the atm-class-name argument, this command displays the
■
information about all the ATM classes.
# Display the information about the ATM class named "main".
<Sysname> display atm class main
ATM CLASS: main
Service ubr 8000
encapsulation aal5snap
Table 23 Description on the fields of the display atm class command
Field
ATM CLASS
command to restore the default.
command to display the information about an ATM
Description
ATM class name
293