Specifying The Ldap Version; Setting The Ldap Server Timeout Period; Configuring Administrator Attributes - H3C SR8800-F Configuration Manual

Step
2. Enter LDAP server view.
3. Configure the IP address of
the LDAP server.

Specifying the LDAP version

Specify the LDAP version on the NAS. The device supports LDAPv2 and LDAPv3. The LDAP
version specified on the device must be consistent with the version specified on the LDAP server.
To specify the LDAP version:
Step
1. Enter system view.
2. Enter LDAP server view.
3. Specify the LDAP version.

Setting the LDAP server timeout period

If the device sends a bind or search request to an LDAP server without receiving the server's
response within the server timeout period, the authentication or authorization request times out.
Then, the device tries the backup authentication or authorization method. If no backup method is
configured in the ISP domain, the device considers the authentication or authorization attempt a
failure.
To set the LDAP server timeout period:
Step
1. Enter system view.
2. Enter LDAP server view.
3. Set the LDAP server
timeout period.

Configuring administrator attributes

To configure the administrator DN and password for binding with the LDAP server during LDAP
authentication:
Step
1. Enter system view.
2. Enter LDAP server view.
Command
ldap server server-name
{ ip ip-address | ipv6
ipv6-address } [ port
port-number ] [ vpn-instance
vpn-instance-name ]
Command
system-view
ldap server server-name
protocol-version { v2 | v3 }
Command
system-view
ldap server server-name
server-timeout time-interval
Command
system-view
ldap server server-name
50
Remarks
N/A
By default, an LDAP server does
not have an IP address.
You can configure either an IPv4
address or an IPv6 address for an
LDAP server. The most recent
configuration takes effect.
Remarks
N/A
N/A
By default, LDAPv3 is used.
A Microsoft LDAP server supports
only LDAPv3.
Remarks
N/A
N/A
By default, the LDAP server timeout
period is 10 seconds.
Remarks
N/A
N/A