T1 Unframed - H3C MSR 20-20 Command Reference Manual

286 C 17: F
HAPTER UNDAMENTAL
View
Parameter
Description
Example

t1 unframed

Syntax
View
Parameter
Description
Related command:
Example
CT3 I C
NTERFACE ONFIGURATION
undo t1 line-number shutdown
CT3 interface view
line-number: T1 line number in the range 1 to 28.
Use the t1 shutdown
Use the
undo t1 shutdown
By default, T1 lines are up.
This command shuts down not only the specified T1 line but also the serial
interfaces formed on it. Data transmission and receiving will stop as a result.
Likewise, the undo t1 shutdown command can bring up all these serial
interfaces.
# Shut down the first T1 line on interface T3 2/0.
<Sysname> system-view
[Sysname] interface t3 2/0
[Sysname-T3 2/0] t1 1 shutdown
t1 line-number unframed
undo t1 line-number unframed
CT3 interface view
line-number: T1 line number in the range 1 to 28.
Use the t1 unframed
unframed mode (T1 mode).
Use the
undo t1 unframed
work in framed mode (CT1 mode).
By default, T1 lines are working in framed mode.
A T1 line in unframed mode does not contain the frame control information; it
cannot be divided into timeslots. For it, the system automatically creates a serial
interface numbered serial number/line-number:0. This interface operates at 1544
kbps and is logically equivalent to a synchronous serial interface on which you can
make other configurations.
t1 channel-set.
# Set the first T1 line on interface T3 2/0 to work in unframed mode.
C
OMMANDS
command to shut down a T1 line on the CT3 interface.
command to bring up a T1 line.
command to set a T1 line on the CT3 interface to work in
command to set the T1 line on the CT3 interface to