Map Bridge; Map Ip - H3C SR8800 Command Reference Manual

Examples
# Enable internal loopback testing on ATM 3/1/1.
<Sysname> system-view
[Sysname] interface Atm 3/1/1
[Sysname-Atm3/1/1] loopback local

map bridge

Syntax
map bridge { virtual-ethernet | ve-bridge } interface-number
undo map bridge
View
PVC view
Default level
2: System level
Parameters
interface-number: Virtual Ethernet (VE) or VE-bridge interface number.
Description
Use the map bridge command to map the current PVC to the specified VE or VE-bridge interface for
IPoEoA or EoA.
Use the undo map bridge command to remove the mapping.
By default, no PVC mapping is configured.
When using this command, make sure that the VE or VE-bridge interface has been created.
Examples
The following examples demonstrate a complete process of IPoEoA configuration.
# Create a VE interface Virtual-Ethernet 3/0/1.
<Sysname> system-view
[Sysname] interface Virtual-Ethernet 3/0/1
# Assign IP address 10.1.1.1/16 to the VE interface.
[Sysname-Virtual-Ethernet3/0/1] ip address 10.1.1.1 255.255.0.0
[Sysname-Virtual-Ethernet3/0/1] quit
# Create PVC 1/102 on the ATM interface ATM 3/1/1.
[Sysname] interface Atm 3/1/1
[Sysname-Atm3/1/1] pvc 1/102
# Map the PVC to the VE interface.
[Sysname-atm-pvc-Atm3/1/1-1/102] map bridge Virtual-Ethernet 3/0/1

map ip

Syntax
map ip { ip-address | default | inarp [ minutes ] } [ broadcast ]
14