Pvp Limit - H3C MSR 20-20 Command Reference Manual

Parameter
Description
Example

pvp limit

Syntax
View
Parameter
Description
max-number: Maximum number of PVCs allowed. The value range varies by the
type of physical interface, as shown in the following table.
Table 29 The maximum number of PVCs supported on different types of ATM interfaces
Interface type
ADSL
GSHDSL
ATM OC3
ATM25
ATME3
ATMT3
Use the pvc max-number
allowed on an ATM interface.
Use the
undo pvc max-number
The maximum number of PVCs allowed varies with interface type.
The maximum number specified in this command is the total number of the PVCs
available to both ATM main interface and the sub-interfaces.
n
The effect of this command applies to both ATM main interface and sub-interface.
However, the command itself is available only in ATM main interface view.
# Configure Atm 1/0 interface to support up to 1,024 PVCs.
<Sysname> system-view
[Sysname] interface atm 1/0
[Sysname-Atm1/0] pvc max-number 1024
pvp limit vpi output-scr
undo pvp limit vpi
ATM interface view
vpi: Virtual path identifier of ATM network; its value ranges from 0 to 255.
output-scr: Sustainable rate of ATM cell output, in kbps. For its detailed value
range, refer to Table 30.
Use the
pvp limit
Use the undo pvp limit
By default, VP policing is not performed.
Maximum number
1 to 32
1 to 32
1 to 1,024
1 to 256
1 to 1,024
1 to 1,024
command to set the maximum number of PVCs
command to restore the default.
command to set the parameters for VP policing.
command to delete the VP policing.
309
Default
32
32
1,024
256
1,024
1,024