Display Atm Map-Info - H3C MSR 20-20 Command Reference Manual

display atm map-info

Syntax
View
Parameter
Description
Example
Table 24 Description on the fields of the display atm interface command
Field
PVCs
MAPs
input pkts: 0, input bytes: 0, input pkt errors: 0
output pkts: 69, output bytes: 2218, output pkt
errors: 8
display atm map-info [ interface interface-type interface-number [ pvc { pvc-name
[ vpi/vci ] | vpi/vci } ] ]
Any view
interface-type interface-number: Specifies an interface by its type and number.
pvc-name: PVC name, a unique string of 1 to 16 characters on ATM interface, not
case-sensitive. The name cannot be the same as a valid VPI/VCI value pair. For
example, the name 1/20 is not allowed.
vpi/vci: VPI/VCI pair. VPI is short for virtual path identifier; its value ranges from 0
to 255. VCI is short for virtual channel identifier; its value range varies by interface
type. Normally, VCI values from 0 to 31 are reserved for special purpose, you are
not recommended to use them. For details regarding the value range, refer to
Table 28.
Use the display atm map-info
ATM interface.
Note that:
Without an interface specified, the system displays the map information for all
■
ATM interfaces.
Without specifying the PVC name or the VPI/VCI value pair, the system displays
■
the map information of all PVCs on the specified ATM interface.
# Display map information for all ATM interfaces.
<Sysname> display atm map-info
Atm1/0, PVC 1/32, PPP, Virtual-Template10, UP
Atm1/0, PVC 1/33, IP & Mask, State UP
100.11.1.1, mask 255.255.0.0, vlink 1
Atm1/0, PVC 2/101, ETH, Virtual-Ethernet1, UP
Table 25 Description on the fields of the display atm map-info command
Field
Atm1/0
PVC 1/33
Description
Number of PVCs configured on the
interface
Number of maps on the interface
Received packets, bytes, and errors
Transmitted packets, bytes, and errors
command to view the map information on an
Description
Interface number
PVC identifier
295