Table of Contents
Advertisement
12.2.4
Notes on Register Access
The watchdog timer's TCNT, TCSR, and RSTCSR registers differ from other registers in being
more difficult to write. The procedures for writing and reading these registers are given below.
Writing to TCNT and TCSR: These registers must be written by a word transfer instruction.
They cannot be written by byte instructions. Figure 12.2 shows the format of data written to
TCNT and TCSR. TCNT and TCSR both have the same write address. The write data must be
contained in the lower byte of the written word. The upper byte must contain H'5A (password for
TCNT) or H'A5 (password for TCSR). This transfers the write data from the lower byte to TCNT
or TCSR.
TCNT write
Address
TCSR write
Address
Note:
*
Lower 20 bits of the address in advanced mode.
Figure 12.2 Format of Data Written to TCNT and TCSR
15
H'FFF8C *
15
H'FFF8C *
8 7
H'5A
8 7
H'A5
Rev. 4.00 Jan 26, 2006 page 469 of 938
Section 12 Watchdog Timer
0
Write data
0
Write data
REJ09B0276-0400
Advertisement
Table of Contents
