Table of Contents
Advertisement
12.3
Operation
Operations when the WDT is used as a watchdog timer and as an interval timer are described
below.
12.3.1
Watchdog Timer Operation
Figure 12.4 illustrates watchdog timer operation. To use the WDT as a watchdog timer, set the
WT/IT and TME bits to 1 in TCSR. Software must prevent TCNT overflow by rewriting the
TCNT value (normally by writing H'00) before overflow occurs. If TCNT fails to be rewritten and
overflows due to a system crash etc., the H8/3067 is internally reset for a duration of 518 states.
The watchdog reset signal can be externally output from the RESO pin to reset external system
devices. The reset signal is output externally for 132 states. External output can be enabled or
disabled by the RSTOE bit in RSTCSR. The RESO pin function is not available in the flash
memory and flash memory R versions.
A watchdog reset has the same vector as a reset generated by input at the RES pin. Software can
distinguish a RES reset from a watchdog reset by checking the WRST bit in RSTCSR.
If a RES reset and a watchdog reset occur simultaneously, the RES reset takes priority.
Section 12 Watchdog Timer
Rev. 4.00 Jan 26, 2006 page 471 of 938
REJ09B0276-0400
Advertisement
Table of Contents
