Renesas H8/3067 Series User Manual page 249

Bit 3—Data Transfer Interrupt Enable (DTIE): Enables or disables the CPU interrupt (DEND)
requested when the DTE bit is cleared to 0.
Bit 3
DTIE Description
0 The DEND interrupt requested by DTE is disabled
1 The DEND interrupt requested by DTE is enabled
Bits 2 and 1—Data Transfer Select 2A and 1A (DTS2A, DTS1A): A channel operates in full
address mode when DTS2A and DTS1A are both set to 1.
Bit 0—Data Transfer Select 0A (DTS0A): Selects normal mode or block transfer mode.
Bit 0
DTS0A Description
0 Normal mode
1 Block transfer mode
Operations in these modes are described in sections 7.4.5, Normal Mode, and 7.4.6, Block
Transfer Mode.
Section 7 DMA Controller
Rev. 4.00 Jan 26, 2006 page 225 of 938
(Initial value)
(Initial value)
REJ09B0276-0400