Pwm Mode - Renesas H8/3067 Series User Manual

9.4.4

PWM Mode

In PWM mode GRA and GRB are paired and a PWM waveform is output from the TIOCA pin.
GRA specifies the time at which the PWM output changes to 1. GRB specifies the time at which
the PWM output changes to 0. If either GRA or GRB is selected as the counter clear source, a
PWM waveform with a duty cycle from 0% to 100% is output at the TIOCA pin. PWM mode can
be selected in all channels (0 to 2).
Table 9.4 summarizes the PWM output pins and corresponding registers. If the same value is set
in GRA and GRB, the output does not change when compare match occurs.
Table 9.4 PWM Output Pins and Registers
Channel Output Pin
0 TIOCA
1 TIOCA
2 TIOCA
1 Output
GRA0
0
GRA1
1
GRA2
2
Section 9 16-Bit Timer
0 Output
GRB0
GRB1
GRB2
Rev. 4.00 Jan 26, 2006 page 373 of 938
REJ09B0276-0400