Table of Contents
Advertisement
7.4.12
Aborting a DMAC Transfer
When the DTE bit in an active channel is cleared to 0, the DMAC halts after transferring the
current byte or word. The DMAC starts again when the DTE bit is set to 1. In full address mode,
the DTME bit can be used for the same purpose. Figure 7.22 shows the procedure for aborting a
DMAC transfer by software.
DMAC transfer abort
Set DTCR
DMAC transfer aborted
Figure 7.22 Procedure for Aborting a DMAC Transfer
1. Clear the DTE bit to 0 in DTCR.
To avoid generating an interrupt when
aborting a DMA transfer, clear the DTIE
bit to 0 simultaneously.
1
Rev. 4.00 Jan 26, 2006 page 259 of 938
Section 7 DMA Controller
REJ09B0276-0400
Advertisement
Table of Contents
