Section 20 Power-Down State
Register Resetting: When an on-chip supporting module is halted by the module standby
function, all its registers are initialized. To restart the module, after its MSTCR bit is cleared to 0,
its registers must be set up again. It is not possible to write to the registers while the MSTCR bit is
set to 1.
MSTCR Access from DMAC Disabled: To prevent malfunctions, MSTCR can only be accessed
from the CPU. It can be read by the DMAC, but it cannot be written by the DMAC.
Rev. 4.00 Jan 26, 2006 page 692 of 938
REJ09B0276-0400