Table 11: Show Ethernet Oam Lfm Discovery Output Fields - Juniper JUNOSE 11.1.X - LINK LAYER CONFIGURATION 4-7-2010 Configuration Manual

Capabilities
Mux Action
Parser Action
Table 11 on page 251 lists the show ethernet oam lfm discovery command output
Meaning
fields.

Table 11: show ethernet oam lfm discovery Output Fields

Field Name
Interface type/name
interfaceSpecifier
Administrative status
OAM status
Local (address)
Mode
Monitoring OAM Link-Fault Management Discovery Settings for an Interface
Chapter 7: Configuring IEEE 802.3ah OAM Link-Fault Management
: link events, loopback, variable retrieval
: Forwarding
: Forwarding
Field Description
Status of the hardware on this interface:
Up Hardware is operational
Down Hardware is not operational
Operational state that you configured for this interface:
Up Interface is enabled
Down Interface is disabled
Status of link-fault management functionality on the interface.
The operational status of an interface does not depend only on
the OAM status. Other factors, such as the administrative state
of the interface, also impact the operational state
Up Link-fault management feature is activated on the
interface
Down Link-fault management feature is disabled on the
interface, either because it was not activated or because it
was turned off as a result of error conditions
MAC address of the interface of the local entity
Discovery mode of the interface of the local OAM entity:
active The interface discovers and monitors the peer on
the link if the peer also supports IEEE 802.3ah OAM
functionality. An OAM entity in active mode initiates the
discovery process by sending an Information OAM PDU to
the multicast address of the slow protocol (0180.c200.0002)
at a configured rate. The default discovery mode of the OAM
client is active
passive An OAM entity does not initiate the discovery
process. You cannot perform link-fault management if you
configure both the local client and the remote peer for
passive mode operation
251