Address Hello-Interval - Juniper JUNOSE 11.1.X - COMMAND REFERENCE A TO M 4-9-2010 Command Reference Manual

address hello-interval

[ no ] address { ipAddress | unnumbered interfaceType interfaceSpecifier }
Syntax
hello-interval helloInterval
Command introduced before JUNOSe Release 7.1.0.
Release Information
Specifies the interval between hello packets that the router sends on the interface.
Description
The no version resets the hello interval to its default.
NOTE: You must issue the address area command before issuing this command.
Options
Router Configuration
Mode
ipAddress OSPF interface address previously specified with the address
command
unnumbered Indicates that OSPF is running on an unnumbered interface
previously specified with the address command
interfaceType Interface type; see "Interface Types and Specifiers" on page 5
interfaceSpecifier—Particular interface; format varies according to interface
type; see Interface Types and Specifiers on page 5
helloInterval Number in the range 1–65535 seconds; default value is 10 seconds
Chapter 2: A Commands
97
address hello-interval