Table 11: Show Ethernet Oam Lfm Discovery Output Fields - Juniper JUNOSE SOFTWARE 11.2.X - LINK LAYER CONFIGURATION GUIDE 7-7-2010 Configuration Manual

JunosE 11.2.x Link Layer Configuration Guide
Meaning
246
Table 11 on page 246 lists the show ethernet oam lfm discovery command output fields.

Table 11: show ethernet oam lfm discovery Output Fields

Field Name
Interface type/name
interfaceSpecifier
Administrative status
OAM status
Local (address)
Mode
Field Description
Status of the hardware on this interface:
Up—Hardware is operational
Down—Hardware is not operational
Operational state that you configured for this interface:
Up—Interface is enabled
Down—Interface is disabled
Status of link-fault management functionality on the interface.
The operational status of an interface does not depend only on
the OAM status. Other factors, such as the administrative state
of the interface, also impact the operational state
Up—Link-fault management feature is activated on the
interface
Down—Link-fault management feature is disabled on the
interface, either because it was not activated or because it was
turned off as a result of error conditions
MAC address of the interface of the local entity
Discovery mode of the interface of the local OAM entity:
active—The interface discovers and monitors the peer on the
link if the peer also supports IEEE 802.3ah OAM functionality.
An OAM entity in active mode initiates the discovery process
by sending an Information OAM PDU to the multicast address
of the slow protocol (0180.c200.0002) at a configured rate.
The default discovery mode of the OAM client is active
passive—An OAM entity does not initiate the discovery process.
You cannot perform link-fault management if you configure
both the local client and the remote peer for passive mode
operation
Copyright © 2010, Juniper Networks, Inc.